Column Pedestal Basin Technical Information
Specification Sheets
300 Series
400 Series
300 Series
400 Series
Pedestal Installation Guide
Column Pedestal Basin installation must be installed by a licensed plumber in accordance with local regulations.
- Remove all products from packaging
- Check the product for damage; if the product is damaged return to your place at purchase.
- Check the product is complete with all components required to install
- The product is to be installed as per Australian standard or local authority requirements.
Installation Instructions
- Select position of the Pedestal Basin
- Unpack column
- Base of column has 3 fixing points
- Remove fixing card template
- Position template on floor and mark fixing points (position card with back arrow facing where the back of the pedestal position will be) BACK OF PEDESTAL IS THE COLUMNS INTERNAL VERTICAL SEAM LINE
- Mark 3 fixing points and lightly mark around base of template
- Drill 3 x 8mm fixing holes
- Tap into hole 3 x plastic plugs
- Position column of pedestal to make sure holes line up
- lay dollops of silicone to aluminium base of column, this silicone will act as a glue to help brace and hold the pedestal in place
- Position pedestal column over fixing holes and on top of silicone, adjust the 3 levelling screws to plumb and level column, Screw base plate into position with 3 galvanised batten screws provided.
- Plumb in waste outlet pipe and connect to supplied trap. Trap should sit facing front to back of column but the offset to the back
- Unpack lightbox and connect wires (24V low voltage 30 watt dimmable transformer required, not supplied) must be connected by an electrician or you will void your warranty.
- Test lightbox is working
- Use electrical tape (black) to tape electrical low voltage wire to waste outlet pipe, we do not recommend transformer sits inside the pedestal column or it will through shadows inside the column.
- Sit lightbox collar into recess in the top of the column, the lightbox should be flush with the top of the column.
- Fit waste to basin,
- Fit waste to trap (supplied) trap should sit facing front to back of column but offset more towards the back
- Measure 40mm waste pipe from trap to sleeve on 40mm floor waste pipe
- Glue 40mm waste pipe and trap into 40mm sleeve of floor waste pipe (make sure trap is pointing front to back of the pedestal, this stops shadows being visible when light is turned on)
- Fit lightbox into recessed at the top of the column, waste pipes should not be touching lightbox
- Lay a small bead of silicone between the lightbox external edge and the pedestal column, this will act as a glue to fix down the basin
- Position basin in centre of column, screw basin waste neck (part B) of universal plug & waste to thread connector (part E) to seal and secure basin in place
Note: to remove wet silicone from basin waste, use a mixture of liquid and water
Cleaning & Maintenance:
Proper care of your quality bathroom products should ensure many years of trouble-free operation. Surfaces should be regularly cleaned with a damp soft cloth or sponge. Mild liquid detergent or soap can also be used for stubborn dirt if necessary.
Precautions:
Use of certain products may cause irreparable damage to the products and must be avoided.
Do not use cleaning agents containing acid, bleach, ammonia or scouring agents such as cream cleaners; and do not use abrasive scouring pads.
Basins should be sealed around all edges with a quality silicone sealant to ensure water cannot get behind under the basin. Your failure to comply with any of the instructions contained within the specific product installation details or this document will void the relevant warranty.
